TDS5000B Online Programmer Guide
-- 6 4 5 --
TEST
Description
This command (no query form) provides the ability to select and exe-
cute an item at any level of the test hierarchy (Test, Area or Subsys-
tem). This command is equivalent to selecting Instrument Diagnostics
from the Utilities menu, choosing a test and then pressing Run.
Note: Turning off both DIAg:CONTROL:HALT and DIAg:CON-
TROL:LOOP before executing the TEST command is recommended.
Group
Diagnostics
Related Commands
TEST:RESults?, TEST:RESults:VERBose?, TEST:STOP
Syntax
TEST
Argument
H <NR3>
This sets the test ID, which ranges from 0 through 3 characters. If no
test ID is specified, all available diagnostics are executed.
Example 1
TEST ”1”
This command executes all Acquisition tests (Subsystem:Acquisition).
Example 2
TEST ”11”
This command executes all Acquisition Memory tests (Subsystem:Ac-
quisition, Area:Memory)
Example 3
TEST ”113”
This command executes a specific Acquisition Memory test (Subsys-
tem:Acquisition, Area:Memory, Test:Address Lines).
To Next Page
Loading...
Need help?
General
