TDS5000B Online Programmer Guide
-- 1 9 --
CURSor:WAVEform:VDELTA? Returns the vertical difference between
waveform cursors
CURSor:WAVEform Sets or returns the current settings for
waveform cursors
CURSor:XY:PRODDELta? Returns the product of the difference
between the cursors X positions and Y
positions
CURSor:XY:PRODUCT<x>? Returns the product of the X and Y
positions for the specified cursor
CURSor:XY:RADIUS<x> Returns the radius of the specified cur-
sor
CURSor:XY:RATDELta? Returns ratio of the difference between
the cursors X position and Y position
CURSor:XY:RATIO<x> Returns ratio of the X (horizontal) and Y
(vertical) position for the specified cur-
sor
CURSor:XY:RDELta? Returns the ∆r value
CURSor:XY:READOUT Sets or returns the XY cursor readout
mode.
CURSor:XY:RECTX<x> Sets or returns the X cursor position in
rectangular coordinates
CURSor:XY:RECTY<x> Sets or returns the Y cursor position in
rectangular coordinates
CURSor:XY:THDELta? Returns the XY cursor angle delta in
polar coordinates
CURSor:XY:THETA<x>? Returns the XY cursor angle in polar
coordinates
CURSor:XY:XDELta? Returns the XY cursor ∆X value in rec-
tangular coordinates
CURSor:XY:YDELta? Returns the XY cursor ∆Y value in rec-
tangular coordinates
CURSor:XY? Returns the current settings for XY cur-
sors
Diagnostic Command Group
The diagnostic commands control the selection and execution of diag-
nostic tests.
Command Description
DIAg:CONTROL:HALT Enables or disables halting on first diag-
nostic failure
DIAg:CONTROL:LOOP Enables or disables looping of diagnos-
tics
DIAg:EXECUTE Executes currently selected set of diag-
nostics
DIAg:ITEM? Returns all data associated with a se-
lected menu item
DIAg:ITEM:FAILURES? Returns the total number of failures that
occurred
DIAg:ITEM:NAMe? Returns the name of the selected menu
item
DIAg:ITEM:RESULT? Returns the results of the last test exe-
cuted on this item
To Next Page
Loading...
Need help?
General
