TDS5000B Online Programmer Guide
-- 4 5 4 --
MASK:STANdard
(TDS5000B Series Option SM)
Description
This command deletes the existing mask (if any) and sets the selected
standard mask. If MASK:COUNt:STATE is ON, mask counting starts
immediately. The query form of this command returns the current mask
standard.
Note: There are several available mask standards that require a higher
bandwidth than permitted for TDS5000B Series instruments. In such
cases, a warning is posted to the standard event system upon selection
of any of these standards. To ensure that the mask you select is fully
supported by the instrument, always check the event status register
after selecting a mask standard.
The following warning event is posted if the mask exceeds the
instrument bandwidth: 2318,”Consider system bandwidth when
testing at this bit rate.”
Group
Mask
Related Commands
ACQuire:MODe
Syntax 1
MASK:STANdard
{ATARXG1|ATARXG2|ATARXG3|ATATXG1|ATATXG2|
ATATXG3|CLOCKCoax|CLOCKSymmet-
rical|D1|D2|DS0Contra|DS0Double|
DS0Single|DS0Timing|DS1|DS1A|DS1C|DS2|DS2RATE-
Coax|
DS2RATESymmet-
rical|DS3|DS4NA|DS4NA_Max|E1Coax|E1Symmetri-
cal|
E2|E3|E4_1|E4_0|ENET1000BCX_ATP2|ENET1000BCX_A
TP3|
ENET1000BCX_NTP2|ENET100FX|ENET100STP|ENET100U
TP|ENET1250|
ENETXAUI_Far|ENET-
XAUI_Near|FC1063|FC1063Draft|FC1063E|
FC1063E_ABR|FC1063E_ABT|FC1063E_ADR|FC1063E_AD
T|FC1063E_AGR|
FC1063E_AGT|FC1063E_NBT|FC1063E_NDT|FC1063E_NG
T|FC133|
FC133E|FC2125|FC2125E_ABR|FC2125E_ABT|FC2125E_
ADR|FC2125E_ADT|
FC2125E_AGR|FC2125E_AGT|FC2125E_NBT|FC2125E_ND
T|FC2125E_NGT|
FC266|FC266E|FC4250E_ABR|FC4250E_ABT
To Next Page
Loading...
Need help?
General
