Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 11 9 --
CH<x>:LABel:XPOS
Description
This command sets or queries the X screen offset at which the label
(attached to the displayed waveform of the specified channel) is dis-
played, relative to the left edge of the screen. The channel is specified
by x. The value of x can range from 1 through 4 for four--channel in-
struments or 1 through 2 for two --channel instruments. This command
is equivalent to selecting Label from the Vertical menu and either view-
ing or setting X Pos.
Group
Vertical
Syntax 1
CH<x>:LABel:XPOS <NR1>
Syntax 2
CH<x>:LABel:XPOS?
Argument
H <NR1>
This is the location (in pixels) where the waveform label for the se-
lected channel is displayed, relative to the left edge of the screen. Ar-
guments should be integers ranging from 0 through 500.
Example 1
CH3:LABel:XPOS 50
This command moves the waveform label for the CH3 waveform so
that it begins 50 pixels to the right of the left edge of the screen.
Example 2
CH2:LABel:XPOS?
This query might return
:CH2:LABEL:XPOS 50
indicating that the waveform label for the CH2 waveform is currently
50 pixels to the right of the left edge of the screen.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet