To Next Page

To Previous Page

TDS5000B Online Programmer Guide

-- 4 0 8 --

MASK:AUTOSet:OFFSETAdj

Description

This command sets autoset to not enforce the rule that, for pulse stan-

dards, require 0V to be in a certain place in the mask. Instead, autoset

will attempt to measure the DC offset in the signal and use scope offset

or position controls to compensate for the DC offset in the signal.

This command, like all the MASK:AUTOSET commands, affects only

an autoset on a standard mask, not the general oscilloscope autoset

function.

Group

Mask

Syntax 1

MASK:AUTOSet:OFFSETAdj {ON|OFF|<NR1>}

Syntax 2

MASK:AUTOSet:OFFSETAdj?

Arguments

H ON

This enables the autoset:offsetadj function.

H OFF

This disables the autoset:offsetadj function.

H <NR1>

A 0 disables the autoset:offsetadj function; any other value enables it.

Example

MASK:AUTOSET:OFFSETADJ ON

Enables the autoset:offsetadj function

Tektronix TDS5000B Series Online Programmer Guide

Other manuals for Tektronix TDS5000B Series