TDS5000B Online Programmer Guide
-- 3 1 4 --
HEADer
Description
This command sets or queries the Response Header Enable State that
causes the instrument to either include or omit headers on query re-
sponses.
Note: This command does not affect IEEE Std 488.2--1987 Common
Commands (those starting with an asterisk); these commands never
return headers. This command does make a corresponding change in
the Response Header Enable State of the opposite interface (physical or
virtual GPIB interface). Refer to Introduction for more information.
Group
Miscellaneous
Related Commands
HDR, VERBose
Syntax 1
HEADer {OFF|ON|<NR1>}
Syntax 2
HEADer?
Arguments
H OFF
This sets the Response Header Enable State to false. This causes the
instrument to omit headers on query responses, so that only the argu-
ment is returned.
H ON
This sets the Response Header Enable State to true. This causes the
instrument to include headers on applicable query responses. You can
then use the query response as a command.
H <NR1>
A 0 sets the Response Header Enable State to false; any other value
sets this state to true, which causes the instrument to omit headers on
query responses.
Example 1
HEADer OFF
This command specifies that the instrument omits headers on query
responses, so that only the argument is returned.
To Next Page
Loading...
Need help?
General
