TDS5000B Online Programmer Guide
-- 5 4 8 --
MEASUrement:IMMed:SOURCE[1]
Description
This command sets or queries the source for all single channel immedi-
ate measurements and specifies the source to measure ”from” when
taking an immediate delay measurement or phase measurement. This
command is equivalent to selecting Measurement Setup from the Mea-
sure menu, choosing the Time tab, clicking the Delay button to display
the delay settings and then clicking the desired Source1 (From) setting.
Note: If you do not specify a numerical suffix, the source is assumed
to be SOURCE 1.
Group
Measurement
Related Commands
MEASUrement:IMMed:SOURCE2
Syntax 1
MEASUrement:IMMed:SOURCE[1]
{CH<x>|MATH<y>|REF<x>|HIStogram}
Syntax 2
MEASUrement:IMMed:SOURCE[1]?
Arguments
H CH<x>
This is an input channel waveform. The x variable can be expressed
as an integer ranging from 1 through 4 for 4--channel models and 1 to
2 for 2--channel models.
H MATH<y>
This is a math waveform. The y variable can be expressed as an inte-
ger ranging from 1 through 4 for 4--channel models and 1 to 2 for
2--channel models.
H REF<X>
This is a reference waveform. The x variable can be expressed as an
integer ranging from 1 through 4 for 4--channel models and 1 to 2 for
2--channel models.
H HIStogram
This indicates histogram as the object to be measured.
Example 1
MEASUrement:IMMed:SOURCE[1] MATH1
This command specifies Math1 as the immediate measurement source .
To Next Page
Loading...
Need help?
General
