Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 5 8 4 --
MEASUrement:MEAS<x>:SOURCE2
Description
This command sets or queries the source for all single channel measure-
ments and specifies the reference source to measure ”to” when taking a
delay measurement or phase measurement. Measurements are specified
by x, which ranges from 1 through 8. This command is equivalent to
selecting Measurement Setup from the Measure menu, selecting a mea-
surement type of either Phase or Delay, and then choosing the desired
measurement source.
Tip: Source2 measurements only apply to phase and delay measure-
ment types, which require both a target (Source1) and reference
(Source2) source.
Group
Measurement
Related Commands
MEASUrement:MEAS<x>:TYPe
Syntax 1
MEASUrement:MEAS<x>:SOURCE2
{CH<x>|MATH<y>|REF<x>}
Syntax 2
MEASUrement:MEAS<x>:SOURCE2?
Arguments
H CH<x>
This is an input channel waveform. The x variable can be expressed
as an integer ranging from 1 through 4 for 4--channel models and 1 to
2 for 2--channel models.
H MATH<y>
This is a math waveform. The y variable can be expressed as an inte-
ger ranging from 1 through 4 for 4--channel models and 1 to 2 for
2--channel models.
H REF<x>
This is a reference waveform. The x variable can be expressed as an
integer ranging from 1 through 4 for 4--channel models and 1 to 2 for
2--channel models.
Example 1
MEASUrement:MEAS4:SOURCE2 CH1
This command specifies CH1 as the delay ”to” source when making
delay measurement.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet