Tektronix TDS5000B Series - Mask:test:aux:completion

TDS5000B Online Programmer Guide
-- 4 6 4 --
MASK:TESt:AUX:COMPLetion
Description
This command sets or returns the test:aux on pass/fail test completion
mode. When enabled, this command causes the oscilloscope to send a
TTL signal out the Aux:Out port when the mask pass/fail status
changes to ‘Failing’. In other words, this command controls whether or
not a TTL signal is sent out the AuxOut port on completion of the pass/
fail test.
Group
Mask
Syntax 1
MASK:TESt:AUX:COMPLetion {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:AUX:COMPLetion?
Arguments
H ON
Turns on the pass/fail mask:test:aux on completion.
H OFF
Turns off the pass/fail mask:test:aux on completion.
H <NR1>
A 0 disables the mask:test:aux:completion function; any other value
enables it.
Example
MASK:TEST:AUX:COMPLETION ON
Turns on the pass/fail test on completion