Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 4 7 0 --
MASK:TESt:LOG:FAILure
Description
This command sets or returns the log status on pass/fail test failure
mode. When enabled, this command causes the oscilloscope to log the
current date and time to a file when the pass/fail status changes to ‘Fail-
ing’. The file name is determined from the current date and time. The
user cannot change this name.
Group
Mask
Related Commands
MASK:TESt:SAVEWFM:FILEName
Syntax 1
MASK:TESt:LOG:FAILure {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:LOG:FAILure?
Arguments
H ON
Turns on the pass/fail log on failure.
H OFF
Turns off the pass/fail log on failure. This is the default.
H <NR1>
A 0 turns off the pass/fail log on failure, and any other integer turns
on the pass/fail log on failure.
Example
MASK:TEST:LOG:FAILURE OFF
Turns off the pass/fail log on failure.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet