Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 7 0 2 --
TRIGger:A:LOGIc:STATE:INPut:CH4
Description
This command sets or queries the slope for channel 4 when the logic
class is set to State in four --channel instruments. This command is
equivalent to selecting Logic State from the Trig menu and then choos-
ing the desired channel input (NEG or POS) from the Ch4 (Clk) drop--
down list.
To set or query the slope of the logic state in two--channel instruments,
see TRIGger:A:LOGIc:STATE:INPut:CH2.
Group
Trigger
Related Commands
TRIGger:A:LOGIc:STATE:WHEn
Syntax 1
TRIGger:A:LOGIc:STATE:INPut:CH4 {FALL|RISe}
Syntax 2
TRIGger:A:LOGIc:STATE:INPut:CH4?
Arguments
H FALL
This specifies falling edge.
H RISe
This specifies rising edge.
Example 1
TRIGger:A:LOGIc:STATE:INPut:CH4?
This query might return
:TRIGGER:A:LOGIC:STATE:INPUT:CH4 RISE
indicating that the A logic trigger input for channel 4 is the rising edge.
Example 2
TRIGger:A:LOGIc:STATE:INPut:CH4 RISE
This command specifies that the A logic trigger input for channel 4 is
the rising edge.