TDS5000B Online Programmer Guide
-- 8 1 --
ACQuire:NUMAVg
Description
This command sets or queries the number of waveform acquisitions
that make up an averaged waveform. Use the ACQuire:MODe com-
mand to enable the Average mode. Sending this command is equivalent
to selecting Horizontal/Acquisition Setup from the Horiz/Acq menu,
selecting the Acquisition tab, and choosing Average from the Acquisi-
tion Mode group box. Then enter the desired number of waveforms that
will be used to make up an averaged waveform in the # of Wfms box.
Group
Acquisition
Related Commands
ACQuire:MODe
Syntax 1
ACQuire:NUMAVg <NR1>
Syntax 2
ACQuire:NUMAVg?
Arguments
H NR1
This is the number of waveform acquisitions to average.
Example 1
ACQuire:NUMAVg 10
This command specifies that 10 waveform averages will be performed
before exponential averaging starts.
Example 2
ACQuire:NUMAVg?
This command might return
:ACQUIRE:NUMAVG 75
indicating that there are 75 acquisitions specified for averaging.
To Next Page
Loading...
