TDS5000B Online Programmer Guide
-- 11 7 --
CH<x>:INVert
Description
This command sets or queries the invert function for the specified chan-
nel. The channel is specified by x. The value of x can range from 1
through 4 for four--channel instruments or 1 through 2 for two--channel
instruments. When on, the invert function inverts the waveform for the
specified channel. This command is equivalent to selecting On or Off
for the Invert function in the Vertical Setup control window.
Note: This command inverts the waveform for display purposes only.
The instrument does not use an inverted waveform for triggers or trig-
ger logic inputs.
Group
Vertical
Syntax 1
CH<x>:INVert {ON|OFF|NR1}
Syntax 2
CH<x>:INVert?
Argument
H OFF
This argument turns off the invert function for the specified channel.
H ON
This argument turns on the invert function for the specified channel.
H <NR1>
A 0 turns off the invert function; any other value turns on the invert
function.
Example 1
CH4:INVert ON
This command inverts the waveform on channel 4.
Example 2
CH2:INVert?
This query might return
:CH2:INVERT 0
indicating that the invert function for channel 2 is off.
To Next Page
Loading...
Need help?
General
