Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 6 9 1 --
TRIGger:A:LOGIc:SETHold:CLOCk:EDGE
Description
This command sets or queries the clock edge polarity for setup and hold
triggering. This is equivalent to selecting Setup/Hold Setup from the
Trig menu and then choosing the desired Clock Edge.
Group
Trigger
Related Commands
TRIGger:A:LOGIc:SETHold:CLOCk:SOUrce, TRIGger:A:LOGIc:SE-
THold:CLOCk:THReshold
Syntax 1
TRIGger:A:LOGIc:SETHold:CLOCk:EDGE {FALL|RISe}
Syntax 2
TRIGger:A:LOGIc:SETHold:CLOCk:EDGE?
Arguments
H FALL
This specifies polarity as the clock falling edge.
H RISe
This specifies polarity as the clock rising edge.
Example 1
TRIGger:A:LOGIc:SETHold:CLOCk:EDGE?
This query might return
:TRIGGER:A:LOGIC:SETHOLD:CLOCK:EDGE RISE
indicating that polarity is specified as the clock rising edge.
Example 2
TRIGger:A:LOGIc:SETHold:CLOCk:EDGE RISE
This command specifies the polarity as the clock rising edge.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet