Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 1 9 5 --
DIAg:CONTROL:LOOP
Description
This command (no query form) determines whether the next execution
of diagnostics executes once or continuously loops on the selected set
of diagnostics (assuming the halt control is set to off using the
DIAg:CONTROL:HALT command or that the halt control is set to ON
but no failures occur). This command is equivalent to selecting Instru-
ment Diagnostics from the Utilities menu and then enabling Loop Con-
trol.
Group
Diagnostics
Related Commands
DIAg:CONTROL:HALT, DIAg:STOP
Syntax
DIAg:CONTROL:LOOP {ON|OFF|<NR1>}
Arguments
H ON
This enables the loop function, causing the execution of diagnostics to
continuously loop.
H OFF
This disables the loop function, causing the oscilloscope to execute
the entire set of diagnostics once and then halt.
H <NR1>
A 0 enables the loop function; any other value disables the loop func-
tion.
Example
DIAg:CONTROL:LOOP ON
This command enables the loop function.

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English