Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 5 3 4 --
MEASUrement:IMMed:DELay:EDGE[1]
Description
This command sets or queries the slope of the edge that is used for the
delay ”from” waveform when taking an immediate delay measurement.
Use the MEASUrement:IMMed:SOURCE1 command to specify the
waveform. This command is equivalent to selecting Measurement Set-
up from the Measure menu, choosing the Time tab, clicking the Delay
button to display the delay settings and then clicking the desired Delay
Edge1 setting.
Note: If you do not specify a numerical suffix, the source is assumed
to be SOURCE 1.
Group
Measurement
Related Commands
MEASUrement:IMMed:SOURCE1
Syntax 1
MEASUrement:IMMed:DELay:EDGE[1] {FALL|RISe}
Syntax 2
MEASUrement:IMMed:DELay:EDGE[1]?
Arguments
H FALL
This specifies the falling edge.
H RISe
This specifies the rising edge.
Example 1
MEASUrement:IMMed:DELay:EDGE[1] RISe
This command specifies that the rising edge be used for the immediate
delay measurement.
Example 2
MEASUrement:IMMed:DELay:EDGE[1]?
This query might return
:MEASUREMENT:IMMED:DELAY:EDGE1 FALL
indicating that the falling edge or negative edge of the waveform is
used for the immediate delay measurement.

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English