TDS5000B Online Programmer Guide
-- 2 8 0 --
EMail:WAVEform
Description
This command sets or queries whether waveform data is included in
e--mail. The waveforms to be included, the start and stop points (and,
or, frames for Fast Frame mode), and the data formats are specified by
the DATA: and WFMOutpre: commands within the Waveform Transfer
Command group.
Group
Email
Syntax 1
EMail:WAVEform {ON|OFF|NR1}
Syntax 2
EMail:WAVEform?
Arguments
H ON
This enables the inclusion of waveform data in e--mail.
H OFF
This disables the inclusion of waveform data in e--mail.
H <NR1>
A 0 disables the inclusion of waveform data in the e--mail; any other
value enables including waveform data in the e--mail.
Example 1
EMail:WAVEform 1
This command enables the inclusion of waveform data in e--mail.
Example 2
EMail:WAVEform?
This query might return
:EMAIL:WAVEFORM 0
This indicates that waveform data is not included in the e--mail.
To Next Page
Loading...
Need help?
General
