TDS5000B Online Programmer Guide
-- 8 6 6 --
2250 Reference error, Waveform
reference file is invalid
2251 Reference error, Waveform
preamble does not match actual
2252 Reference error, Source wfm is not
valid
2253
Reference error, Too many points
received
2254 Reference error, Too few points
received
2259 File too big
2261
Calibration error, wait for the
warmup interval to expire before
invoking SPC
2400 Not enough memory available
2401 This channel cannot be activated
2402
Math/Meas/Histo have circular
definition
2410 Empty math string
2411 Syntax error in math string
2412 Semantic error in math string
2413 Math expression is too complex
2420 Histogram cannot be performed on
this type of wfm
Device Error
The following table lists the device errors that can occur during instru-
ment operation. These errors may indicate that the instrument needs
repair.
Device Error Messages (DDE Bit 3)
Code Message
300 Device--specific error
310 System error
311 Memory error
312 PUD memory lost
313 Calibration memory lost
314 Save/recall memory lost
315 Configuration memory lost
350 Queue overflow (does not set DDE bit)
System Event
The following table lists the system event messages. These messages
are generated whenever certain system conditions occur.
To Next Page
Loading...
Need help?
General
