2-28 Service Manual
5058-030
381.34
Service finisher error
Sensor (booklet rear tamper HP) lag
error
The sensor (booklet rear tamper HP)
activated, but did not clear within the
specified time.
Go to “381.34 Sensor (booklet rear
tamper HP) lag jam” on page 2-167.
381.35
Service finisher error
Sensor (booklet knife folding) failure The sensor (booklet knife folding)
activated, but did not clear within the
specified time.
Go to “381.35 Sensor (booklet knife
folding) failure” on page 2-169.
381.36
Service finisher error
Booklet unit failure The booklet unit is detected as open after
power on.
Go to “381.36 Booklet unit fail” on
page 2-170.
381.37
Service finisher error
Sensor (booklet knife HP) late error The sensor (booklet knife HP) activated,
but did not clear within the specified time.
Go to “381.37 Sensor (booklet knife HP)
late jam” on page 2-171.
381.38
Service finisher error
Sensor (booklet knife HP) lag error The sensor (booklet knife HP) activated,
but did not clear within the specified time.
Go to “381.38 Sensor (booklet knife HP)
lag jam” on page 2-173.
381.39
Service finisher error
Booklet stapler error The booklet stapler unit is not completely
inserted into the booklet maker unit
assembly or it has failed.
Go to “381.39 Booklet Staple Fail” on
page 2-175.
381.40
Service finisher error
Sensor (booklet compiler media
present) error
The sensing area of the sensor (booklet
compiler no media) did not detect any
media when the booklet stapler motor was
activated.
Go to “381.40 Sensor (booklet compiler
media present) error” on page 2-176.
381.41
Service finisher error
Communication error with booklet
controller card assembly
A communication error has occurred with
the booklet controller card assembly and
the finisher controller card assembly.
Go to “381.41 Communication error with
booklet controller card assembly” on
page 2-177.
3xx service errors
Error code Description Action
To Next Page
Loading...
Need help?
General
