Lexmark C950 - Page 81

Diagnostic information 2-33
5058-030
Go Back
Previous
Next
956.00
Service system board
error
RIP card assembly processor failure The RIP card processor has failed.
Go to “956.00 RIP card assembly
processor failure” on page 2-217.
956.01
Service system board
error
RIP card assembly processor over
temperature failure
The RIP card assembly has exceeded safe
operating temperature.
Go to “956.01 RIP card assembly
processor over temperature failure” on
page 2-217.
956.02
Service system board
error
RIP card assembly cooling fan failure The RIP card assembly cooling fan is not
functioning properly.
Go to “956.02 RIP card assembly
cooling fan failure” on page 2-217.
956.03
Service system board
error
RIP card assembly FPGA failure The RIP card assembly has failed.
Go to “956.03 RIP card assembly FPGA
failure” on page 2-218.
957.01
Service data error
BITZ1 initialize failure A data-loading error has occurred.
Go to “957.01 BITZ1 initialize failure” on
page 2-219.
957.02
Service data error
BITZ2 initialize failure A data-loading error has occurred.
Go to “957.02 BITZ2 initialize failure” on
page 2-219.
980.04
Service duplex
comm.
Duplex controller card assembly
communication failure
A communication error occurred between
the printer engine card assembly and the
duplex controller card assembly.
Go to “980.04 Duplex controller card
assembly communication failure” on
page 2-218.
980.05
Service flicker
communication error
Engine flicker communication failure A communication error has occurred in the
printer engine card assembly.
Go to “980.05 Engine flicker
communication failure” on page 2-219.
995.00
Service finisher NVM
error
Finisher NVM R/W failure A read/write error occurred on the NVM of
the finisher controller card assembly.
Go to “995.00 Finisher NVM R/W failure”
on page 2-220.
9xx service error codes
Error code Description Action