TDS5000B Online Programmer Guide
-- 3 1 --
Command
Description
LIMit:BEEP
Sounds beep when limit exceeded
LIMit:COMpare
Resets the Limit test comparison
template
LIMit:COMpare:CH<x>
Sets or returns the waveform tem-
plate to which the specified wave-
form is compared
LIM-
it:COMpare:MATH<x>
Sets or returns the waveform tem-
plate to which the specified math wa-
veform is compared
LIMit:COMpare:REF<x>
Sets or returns the waveform tem-
plate to which the specified reference
waveform is compared
LIMit:EMail
Sets or queries whether an e--mail is
generated when the source wave-
form data exceeds test limits
LIMit:HARDCopy
Sets or returns whether a hardcopy
operation is executed on the wave-
form when any waveform data ex-
ceeds the limit set in the limit test
LIMit:HIGHLIGHTHits
Sets or queries whether violation
highlighting occurs when limit testing
is active; also, clears any highlighted
hits in the mask display
LIMit:LOCk
Sets or queries whether vertical scal-
ing and positioning affect both the
source and template for template
comparison pairs
LIMit:LOG
Sets or queries whether a log file is
saved when the source waveform
data exceeds the test limits
LIMit:SAVEWFM
Sets or queries whether the source
waveform is saved when the source
waveform data exceeds the test lim-
its
LIMit:SAVEWFM:FILEName
Sets or queries the path where wave-
forms or log files will be saved when
the waveform data exceeds the limits
set by the limit test
LIMit:SRQ
Sets or queries whether an SRQ is
sent when the waveform data ex-
ceeds the test limits
LIMit:STATE
Sets or returns whether limit testing
is on or off
LIMit:STOPOnviolation
Sets or queries whether acquisitions
are stopped when the waveform data
exceeds the test limits
LIMit:TEMPlate:STORe
Saves the specified source waveform
to a specified file or reference
LIMit:TEMPlate:TOLer-
ance:HORizontal
Sets or queries the amount, in units
of horizontal divisions, by which the
source waveform is varied horizontal-
ly when creating the destination wa-
veform