Tektronix TDS5000B Series - Page 908

TDS5000B Online Programmer Guide
-- 8 8 8 --
MEASUREMENT:STATISTICS:MODE ALL
MEASUREMENT:STATISTICS:WEIGHTING 32
Miscellaneous Default Values
The following table lists the Miscellaneous factory default setup values.
Command Default Values
ALIAS:STATE 0 (OFF)
AUXOUT:EDGE FALLING <cannot change>
AUXOUT:SOURCE ATRIGGER
CMDBATCH 1 (ON)
HEADER 1 (ON)
LOCK NONE
ROSC:SOURCE INTERNAL
VERBOSE 1 (ON)
Save and Recall Default Settings
The following table lists the Save and Recall factory default setup val-
ues.
Command Default Values
SAVE:WAVEFORM:FILEFORMAT INTERNAL
Trigger Default Values
The following table lists the Trigger factory default setup values.
Command Default Values
TRIGGER:A:COMMUNICATION:AMI:PULSEFORM PLUSONE
TRIGGER:A:COMMUNICATION:AMI:THRESHOLD:HIGH 0.0000
TRIGGER:A:COMMUNICATION:AMI:THRESHOLD:LOW 0.0000
TRIGGER:A:COMMUNICATION:BITRATE 1544000
TRIGGER:A:COMMUNICATION:CLOCK:POLARITY RISE
TRIGGER:A:COMMUNICATION:CMI:PULSEFORM PLUSONE
TRIGGER:A:COMMUNICATION:CODE NRZ
TRIGGER:A:COMMUNICATION:SOURCE CH1
TRIGGER:A:COMMUNICATION:SOURCE:TYPE DATA