Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 8 9 7 --
Interface Messages
The following table shows the standard interface messages that the in-
strument supports.
Standard Interface Messages
Message GPIB
DCL Yes
GET Yes
GTL Yes
LLO Yes
PPC No*
PPD No*
PPE No*
PPU No*
SDC Yes
SPD Yes
SPE Yes
TCT No*
UNL Yes
UNT Yes
Listen Addresses Yes
Talk Addresses Yes
*This instrument may be operated as a GPIB
controller or as a device. When Operated in
controller mode, your controller software
should respond to these interface messages.
The instrument will not respond to these
messages when the GPIB port is used as a
device.