Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 3 5 --
MASK:MASKPRE:WIDth
Sets or returns the nominal bit width in
seconds
MASK:POLarity
Sets or returns the input waveform po-
larity for the pass/fail test
MASK:SEG<m> DELEte
Deletes the specified mask segment
from the Current mask
MASK:SEG<m>:NR_Pt?
Returns the number of points that
make up the specified mask segment
of the Current mask
MASK:SEG<m>:POINTS
Sets or returns the X--Y user coordi-
nates of all points in the Current mask
segment
MASK:SOUrce
Sets or reports which source will be
compared against the mask(s) when
counting is turned on
MASK:STANdard
Deletes the existing mask and sets the
selected standard mask
MASK:STOPOnviolation
Sets or returns the stop on violation
setting
MASK:TESt:AUX:COMPLe-
tion
Sets or returns the test:aux on pass/fail
test completion mode
MASK:TESt:AUX:FAILure
Sets or returns the test:aux status on
pass/fail test failure mode
MASK:TESt:BEEP:COMPL
etion
Sets or returns the beep on pass/fail
test completion mode
MASK:TESt:BEEP:FAILure
Sets or returns the beep status on
pass/fail test failure mode
MASK:TESt:DELay
Sets or returns the amount of time, in
seconds, to wait after starting pass/fail
testing to evaluate waveforms
MASK:TESt:HARDCopy
Sets or returns the hard copy in pass/
fail failure mode
MASK:TESt:LOG:FAILure
Sets or returns the log status on pass/
fail test failure mode
MASK:TESt:REPeat
Sets or returns the repeat pass/fail test
on completion mode
MASK:TESt:SAMple
Sets or returns the minimum number of
waveform database (WfmDB) points
the oscilloscope can acquire before it
stops a single sequence acquisition or
stops running a mask test
MASK:TESt:SAM-
ple:THReshold
Sets or returns the minimum number of
hits in mask regions needed to cause
the pass/fail status to change from
PASSING to FAILING
MASK:TESt:SAVEWFM
Sets or returns the save waveform to
file on failure setting
MASK:TESt:SA-
VEWFM:FILEName
Sets or returns the name of the direc -
tory and file to use with the
MASK:TESt:SAVEWFM command
MASK:TESt:SRQ:COMPLe-
tion
Sets or returns an SRQ on pass/fail
test completion mode
MASK:TESt:SRQ:FAILure
Sets or returns the SRQ status on
pass/fail test failure mode
MASK:TESt:STATE
Sets or returns the state of mask pass/
fail testing

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English