NETGEAR ProSAFE M7100-24X - Monitor Session Mode; Monitor Session Filter

Switching Commands
102
ProSAFE M7100 Managed Switches
Using the following options, you can specify a specific source for the session.
monitor session filter
This command configures a filter to be mirrored. As the filter, you can define a MAC ACL or an IP
ACL. For an IP ACL, you can specify an ID or a name. For a MAC ACL, you can specify a name only.
The <session-id> parameter is an integer value that is used to identify the session. However, you
always need to enter 1 for the <session-id> parameter.
monitor session mode
This command enables the administrative mode of the port-mirroring session. If enabled, the
probe port monitors the following traffic:
• Source port. All the traffic received, transmitted, or both received and transmitted,
depending on the setting of the optional rx/tx parameter.
• Filter. All the traffic received on the IP ACL or MAC ACL.
Parameters Description
destination interface Use the interface <unit/slot/port> parame
ter to specify the interface
to receive the monitored traffic.
destination remote vlan Create an RSPAN VLAN on the intermediate switch. Configure the ports that are
connec
ted to the source switch and destination switch as participants in the
RSPAN VLAN. Enable RSPAN VLAN egress tagging on the interface on the
intermediate switch that is connected to the destination switch. Use the remote
vlan <vlan-id> parameter to specify the RSPAN VLAN.
Use the reflector-port <unit/slot/port> parame
ter to configure the
reflector port at the source switch. The reflector port forwards the mirrored
traffic to the destination switch.
Default You need to enter 1 for the <session-id> parame
ter.
Format monitor session <session-id> filter {ip access-group {<acl-id> |
<acl-name>} | mac access-group <acl-name>}
Mode Global Config
Default You need to enter 1 for the <session-id> parame
ter.
Format monitor session <session-id> mode
Mode Global Config