Quality of Service (QoS) Commands
251
ProSAFE M7100 Managed Switches
mac access-list extended rename
This command changes the name of a MAC access control list (ACL). The <name> parameter is
the name of an existing MAC ACL. The <newname> parameter is a case-sensitive alphanumeric
string from 1 to 31 characters uniquely identifying the MAC access list.
This command fails if a MAC ACL by the name <newname> exis
ts.
permit (MAC ACL)
and
deny (MAC ACL)
These commands create a new rule for the current MAC access list. Each rule is appended to the
list of configured rules for the list.
Note: The 'no' form of these commands is not supported, since the rules
within a MAC ACL cannot be deleted individually. Rather, the entire
MAC ACL must be deleted and respecified.
Note: An implicit 'deny all' MAC rule always terminates the access list.
A rule might either deny or permit traffic according to the specified classification fields. At a
minimum, the sourc
e and destination MAC value must be specified, each of which might be
substituted using the keyword any to indicate a match on any value in that field. The remaining
command parameters are all optional, but the most frequently used parameters appear in the
same relative order as shown in the command format.
The Ethertype might be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF
. The cur
rently supported <ethertypekey> values are: appletalk, arp, ibmsna,
ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into
its equivalent Ethertype value(s).
The time-range parame
ter allows imposing time limitation on the MAC ACL rule as defined by
the parameter time-range-name. If a time range with the specified name does not exist and
the MAC ACL containing this ACL rule is applied to an interface or bound to a VLAN, the ACL rule
is applied immediately. If a time range with the specified name exists and the MAC ACL containing
this ACL rule is applied to an interface or bound to a VLAN, the ACL rule is applied when the
time-range with the specified name becomes active. The ACL rule is removed when the
time-range with the specified name becomes inactive.
Format mac access-list extended rename <name> <newname>
Mode Global Config
To Next Page
Loading...
Need help?
General