NETGEAR ProSAFE M7100-24X - Show Igmpsnooping

Switching Commands
116
ProSAFE M7100 Managed Switches
no set igmp header-validation
This command disabled the IGMP IP header validation..
show igmpsnooping
This command displays IGMP Snooping information. Configured information is displayed whether
or not IGMP Snooping is enabled.
When the optional arguments <slot/port> or <vlan_id> are no
t used, the command
displays the following information:
When you specify the <slot/port> values, the f
ollowing information appears:
Default Enabled
Format set igmp header-validation
Mode Global Config
Format no set igmp header-validation
Mode Global Config
Format show igmpsnooping [<slot/port> | <vlan_id>]
Mode Privileged EXEC
Term Definition
Admin Mode Indicates whether or not IGMP Snooping is active on the switch.
Multicast Control
Fr
ame Count
The number of multicast control frames that are processed by the CPU.
Interface Enabled
for IGMP
Snooping
The lis
t of interfaces on which IGMP Snooping is enabled.
VLANS Enabled
for IGMP
Snooping
The lis
t of VLANS on which IGMP Snooping is enabled.
Term Definition
IGMP Snooping
Admin Mode
Indicates whether IGMP Snooping is active on the interface.
Fast Leave Mode Indicates whether IGMP Snooping Fast-leave is active on the interface.