NETGEAR ProSAFE M7100-24X Reference Manual

Management Commands
501
ProSAFE M7100 Managed Switches
no login authentication
Use this command to return to the default specified by the
login authentication command.
enable authentication
Use this command in line configuration mode to specify an authentication method list when the
user accesses a higher privilege level in remote telnet or console.
no enable authentication
Use this command to return to the default specified by the
enable authentication command.
show serial
Use this command to display serial communication settings for the switch.
Format no login authentication {default | <list-name>}
Mode Line Config
Format enable authentication {default | <list-name>}
Mode Line Config
Format no enable authentication {default | <list-name>}
Mode Line Config
Format show serial
Modes • Privileged EXEC
• User EXEC
Term Definition
Serial Port Login
Timeout
(minut
es)
The time, in minutes, of inactivity on a Serial port connection, after which the Switch will
close the connection. Any numeric value from 0 through 160 is allowed, the factory default
is 5. A value of 0 disables the timeout.
Baud Rate (bps) The default baud rate at which the serial port will try to connect. The available values are
1200, 2400, 4800, 9600, 19200, 38400,57600, and 115,200 baud. The f
ac
tory default
is 9600 baud.
Character Size
(bits)
The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is always
disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is always 1.
Parity Type The parity method used on the serial port. The parity method is always None.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English