Utility Commands
370
ProSAFE M7100 Managed Switches
show eventlog
This command displays the event log, which contains error messages from the system. The event
log is not cleared on a system reset. The optional <unit> parameter is the switch identifier.
Note: Event log information is retained across a switch reset.
show hardware
This command displays inventory information for the switch.
Note: The show version command and the show hardware command display
the same information. In future releases of the software, the show
hardware command will not be available. For a description of the
command output, see the command show version on page 388.
show environment
This command displays information about the temperature and status of the power supplies and
fans in the system chassis.
Format show eventlog [<unit>]
Mode Privileged EXEC
Term Definition
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Unit The unit for the event.
Format show hardware
Mode Privileged EXEC
Format show environment
Mode Privileged EXEC
To Next Page
Loading...
