NETGEAR ProSAFE M7100-24X - Boot Host Dhcp; Erase Startup-Config

Utility Commands
366
ProSAFE M7100 Managed Switches
no boot host retry-count
This command is used to reset the number to the default. The default number is 3.
boot host dhcp
This command is used to enable AutoInstall on the switch for the next reboot cycle. The command
does not change the current behavior of AutoInstall and saves the command to NVRAM.
no boot host dhcp
This command is used to disable AutoInstall on the switch for the next reboot cycle. The
command does not change the current behavior of AutoInstall and saves the command to NVRAM
erase startup-config
Use this command to erase the text-based configuration file stored in non-volatile memory. If
the switch boots and no startup-config file is found, the AutoInstall process automatically begins.
Format no boot host retry-count
Mode Privileged EXEC
Default Enabled
Format boot host dhcp
Mode Privileged EXEC
Format no boot host dhcp
Mode Privileged EXEC
Format erase startup-config
Mode Privileged EXEC