NETGEAR ProSAFE M7100-24X - Lldp Med Confignotification All; Lldp Med Faststartrepeatcount

Switching Commands
147
ProSAFE M7100 Managed Switches
no lldp med all
Use this command to remove LLDP-MD on all ports.
lldp med confignotification all
Use this command to configure all the ports to send the topology change notification.
no lldp med confignotification all
Use this command to disable all the ports to send the topology change notification.
lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. [count] is the number of
LLDP PDUs that will be transmitted when the product is enabled. The range is 1 to 10.
no lldp med faststartrepeatcount
Use this command to return to the factory default value.
Format no lldp med all
Mode Global Config
Format
lldp med confignotification all
Mode Global Config
Format no lldp med confignotification all
Mode Global Config
Default 3
Format lldp med faststartrepeatcount [count]
Mode Global Config
Format no lldp med faststartrepeatcount
Mode Global Config