Utility Commands
475
ProSAFE M7100 Managed Switches
IP Address Conflict Commands
ip address-conflict-detect run
This command triggers the switch to run active address conflict detection by sending gratuitous
ARP packets for IPv4 addresses on the switch.
Note: This command takes effect only once after it is executed and cannot be
saved across power cycles.
show ip address-conflict
This command displays the status information corresponding to the last detected address
conflict.
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Link Local Protocol Filtering Commands
Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary
protocols running on standards-based switches. If certain protocol PDUs cause unexpected
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the switch.
Format ip address-conflict-detect run
Mode Global Config
Term Definition
Address Conflict
Det
ection Status
Identifies whether the switch has detected an address conflict on any IP address.
Last Conflicting IP
Addres
s
The IP Address that was last detected as conflicting on any interface.
Last Conflicting
MAC Addr
ess
The MAC Address of the conflicting host that was last detected on any interface.
Time Since
Conflic
t Detected
The time in days, hours, minutes and seconds since the last address conflict was detected.
Format clear ip address-conflict-detect
Mode Privileged EXEC
To Next Page
Loading...
