NETGEAR ProSAFE M7100-24X - Show Ip Interface

Routing Commands
186
ProSAFE M7100 Managed Switches
show ip interface
This command displays all pertinent information about the IP interface.
Format show ip interface {<slot/port> | vlan <1-4093> | loopback <0-7>}
Modes • Privileged EXEC
• User EXEC
Term Definition
Routing Interface
St
atus
Determine the operational status of IPv4 routing Interface. The possible values are Up or
Down.
Primary IP
Addres
s
The primary IP address and subnet masks for the interface. This value appears only if you
configure it.
Secondary IP
Addres
s
One or more secondary IP addresses and subnet masks for the interface. This value appears
only if you configure it.
Method Shows whether the IP address was configured manually or acquired from a DHCP server.
Routing Mode The administrative mode of router interface participation. The possible values are enable or
disable. This v
alue is c
onfigurable.
Administrative
Mode
The administrative mode of the specified interface. The possible values of this field are
enable or disable. This value is c
onfigurable.
Forward Net
Direc
ted
Broadcasts
Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
value is configurable.
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the interface.
Active State Displays whether the interface is active or inactive. An interface is considered active if its link
is up and it is in f
or
warding state.
Link Speed Data
Rate
An int
eger representing the physical link data rate of the specified interface. This is measured
in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-digit
hex
adecimal numbers that are separated by colons.
Encapsulation
Type
The enc
apsulation type for the specified interface. The types are: Ethernet or SNAP.
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth Shows the bandwidth of the interface.
Destination
Unr
e
achables
Displays whether ICMP Destination Unreachables might be sent (enabled or disabled).
ICMP Redirects Displays whether ICMP Redirects might be sent (enabled or disabled).