Management Commands
549
ProSAFE M7100 Managed Switches
snmp trap link-status all
Use this command to enable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. For
more information, see snmp-server enable traps linkmode on
page 545.
no snmp trap link-status all
Use this command to disable link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. For
more information, see snmp-server enable traps linkmode on
page 545.
show snmpcommunity
Use this command to display SNMP community information. Six communities are supported. You
can add, change, or delete communities. The switch does not need to be reset for changes to take
effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends tr
aps through TCP/IP
to an external SNMP manager based on the SNMP configuration (the trap receiver and other
SNMP community parameters).
Format snmp trap link-status all
Mode Global Config
Format no snmp trap link-status all
Mode Global Config
Format show snmpcommunity
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General