Log Messages
612
ProSAFE M7100 Managed Switches
Technologies
Table 60. System General Error Messages
Component Message Cause
OS Invalid USP unit = x, slot = x, port =x A port was not translated correctly.
OS In hapiBroadSystemMacAddress call to
'bcm_l2_addr_add' - FAILED : x
F
ailed to add an L2 address to the MAC table.
This should only happen when a hash collision
occurs or the table is full.
OS Failed installing mirror action - rest of the
polic
y applied suc
cessfully
A previously configured probe port is not
being used in the policy. The release notes
state that only a single probe port can be
configured
OS Policy x does not contain rule x The rule was not added to the policy due to a
discr
epanc
y in the rule count for this specific
policy. Additionally, the message can be
displayed when an old rule is being modified,
but the old rule is not in the policy
OS ERROR: policy x, tmpPolicy x, size x, data x x
x x x x x x
An issue installing the policy due to a possible
duplic
at
e hash
OS ACL x not found in internal table Attempting to delete a non-existent ACL
OS ACL internal table overflow Attempting to add an ACL to a full table
OS In hapiBroadQosCosQueueConfig, Failed to
c
onfigur
e minimum bandwidth. Available
bandwidth x
Attempting to configure the bandwidth
beyond its capabilities
OS USL: failed to put sync response on queue A response to a sync request was not
enqueued. This c
ould indic
ate that a previous
sync request was received after it was timed
out
OS USL: failed to sync ipmc table on unit=x Either the transport failed or the message
w
as dr
opped
OS usl_task_ipmc_msg_send(): failed to send
with x
Either the transport failed or the message
was dr
opped
OS USL: No available entries in the STG table The Spanning Tree Group table is full in USL
OS USL: failed to sync stg table on unit=x Could not synchronize unit x due to a
tr
anspor
t failure or API issue on remote unit.
A synchronization retry will be issued
OS USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t
e
xis
t
OS USL: A Trunk being created by bcmx already
exis
ted in USL
Possible synchronization issue between the
application, hardware, and sync layer
To Next Page
Loading...
Need help?
General