NETGEAR ProSAFE M7100-24X - Dot1 X Port-Control All; Dot1 X Re-Authenticate

Security Commands
294
ProSAFE M7100 Managed Switches
no dot1x port-control
This command sets the 802.1x port control mode on the specified port to the default value.
dot1x port-control all
This command sets the authentication mode to use on all ports. Select force-unauthorized
to specify that the authenticator PAE unconditionally sets the controlled port to unauthorized.
Select force-authorized to specify that the authenticator PAE unconditionally sets the
controlled port to authorized. Select auto to specify that the authenticator PAE sets the
controlled port mode to reflect the outcome of the authentication exchanges between the
supplicant, authenticator, and the authentication server. If the
mac-based option is specified,
MAC-based dot1x authentication is enabled on the port.
no dot1x port-control all
This command sets the authentication mode on all ports to the default value.
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is “auto” or “mac-based”. If the control mode is
not “auto” or “mac-based”, an error will be returned.
Format no dot1x port-control
Mode Interface Config
Default auto
Format dot1x port-control all {force-unauthorized | force-authorized | auto
| mac-based}
Mode Global Config
Format no dot1x port-control all
Mode Global Config
Format dot1x re-authenticate <slot/port>
Mode Privileged EXEC