NETGEAR ProSAFE M7100-24X - LLDP (802.1 AB) Commands; Lldp Transmit; Lldp Receive

Switching Commands
136
ProSAFE M7100 Managed Switches
When the optional argument <detail> is used, the command shows the global information and
the information for all Querier-enabled VLANs.
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol (LLDP),
which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802 LAN to
advertise major capabilities and physical descriptions. The advertisements allow a network
management system (NMS) to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability.
no lldp transmit
Use this command to return the local data transmission capability to the default.
lldp receive
Use this command to enable the LLDP receive capability.
Querier VLAN
Address
The IP address will be used in the IPv6 header while sending out MLD queries on this VLAN.
It can be configured using the appropriate command.
Operational
Ver
sion
This version of IPv6 will be used while sending out MLD queriers on this VLAN.
Last Querier
Addres
s
Indicates the IP address of the most recent Querier from which a Query was received.
Last Querier
Ver
sion
Indicates the MLD version of the most recent Querier from which a Query was received on
this VLAN.
Default enabled
Format lldp transmit
Mode Interface Config
Format no lldp transmit
Mode Interface Config
Default enabled
Format lldp receive
Mode Interface Config
Field Description