Utility Commands
381
ProSAFE M7100 Managed Switches
The following is an example of the CLI command output:
(Netgear Switch) #show interfaces status 0/5
Link Physical Physical Media Flow Control
Port Name State Mode Status Type Status
------ -------------- ------ ---------- ---------- --------------- ----------
0/5 Up Auto 1000 Full 100/1000-BaseTx Inactive
Flow Control:Disabled
show mac-addr-table
This command displays the forwarding database entries. These entries are used by the
transparent bridging function to determine how to forward a received frame.
Enter all or no parameter to display the entire table. Enter a MAC Address and VLAN ID to
display the table entry for the requested MAC address on the specified VLAN. Enter the count
parameter to view summary information about the forwarding database table. Use the
interface <slot/port> parameter to view MAC addresses on a specific interface. Use the
vlan <vlan_id> parameter to display information about MAC addresses on a specified VLAN.
The following information displays if you do not enter a parameter, the keyword all, or the MAC
addres
s and VLAN ID. If you enter vlan <vlan_id>, only the Mac Address, Interface, and
Status fields appear.
Format show interfaces status [<interface>]
Mode Privileged EXEC
Format show mac-addr-table [{<macaddr> <vlan_id> | all | count | interface
<slot/port> | vlan <vlan_id>}]
Mode Privileged EXEC
Term Definition
Mac Address A unicast MAC address for which the switch has forwarding and or filtering information. The
format is 6 or 8 tw
o-digit hexadecimal numbers that are separated by colons, for example
01:23:45:67:89:AB. In an IVL system the MAC address will be displayed as 8 bytes.
Interface The port through which this address was learned.
Interface Index This object indicates the ifIndex of the interface table entry associated with this port.
To Next Page
Loading...
Need help?
General