NETGEAR ProSAFE M7100-24X Reference Manual

Utility Commands
421
ProSAFE M7100 Managed Switches
For each configured server:
show sntp source-interface
Use this command to display the SNTP client source interface on the switch.
Server Reference
ID
Reference clock identifier of the server for the last received valid packet.
Server Mode SNTP Server mode.
Server Maximum
Entries
Total number of SNTP Servers allowed.
Server Current
Entries
Total number of SNTP configured.
Term Definition
Host Address IP address or hostname of configured SNTP Server.
Address Type Address Type of configured SNTP server.
Priority IP priority type of the configured server.
Version SNTP version number of the server. The protocol version used to query the server in unicast
mode.
Port Server port number.
Last Attempt
T
ime
Las
t server attempt time for the specified server.
Last Update
St
atus
Last server attempt status for the server.
Total Unicast
Reques
ts
Number of requests to the server.
Failed Unicast
Reques
ts
Number of failed requests from server.
Format show sntp source-interface
Mode Privileged EXEC
Term Definition
SNTP Client Source
Inter
face
The interface ID of the physical or logical interface that is configured as the SNTP client
source interface.
SNTP Client Source
IPv4 Addres
s
The IP address of the interface that is configured as the SNTP client source interface.
Term Definition

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English