NETGEAR ProSAFE M7100-24X - Protocol Group; Protocol Vlan Group

Switching Commands
55
ProSAFE M7100 Managed Switches
no vlan protocol group add protocol
This command removes the <protocol> from this pr
otocol-based VLAN group that is
identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>. A
group may only be associated with one VLAN at a time, however the VLAN association can be
changed.
no protocol group
This command removes the <vlanid> from this pr
otocol-based VLAN group that is identified
by this <groupid>.
protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate each
interface and protocol combination with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command fails and the
interface(s) are not added to the group.
Format no vlan protocol group add protocol <groupid> ethertype
{<protocol-list> | arp | ip | ipx}
Mode Global Config
Default none
Format protocol group <groupid> <vlanid>
Mode VLAN Config
Format no protocol group <groupid> <vlanid>
Mode VLAN Config
Default none
Format protocol vlan group <groupid>
Mode Interface Config