NETGEAR ProSAFE M7100-24X - Dhcp L2 Relay Vlan; Dhcp L2 Relay Circuit-ID Vlan; Dhcp L2 Relay Remote-ID Vlan

Switching Commands
105
ProSAFE M7100 Managed Switches
dhcp l2relay circuit-id vlan
Use this parameter to set the DHCP Option-82 Circuit ID for a VLAN. When enabled, the
interface number is added as the Circuit ID in DHCP option 82. Vlan-list range is 1–4093.
Separate non-consecutive IDs with a comma (,), and do not insert spaces or zeros in between the
range. Use a dash (–) for the range.
no dhcp l2relay circuit-id vlan
Use this parameter to clear the DHCP Option-82 Circuit ID for a VLAN.
dhcp l2relay remote-id vlan
Use this command to set the DHCP Option-82 Remote ID for a VLAN and subscribed service
(based on subscription-name). The vlan–list range is 1–4093. Separate non-consecutive IDs
with a comma (,), and do not insert spaces or zeros between the range. Use a dash (–) for the
range.
no dhcp l2relay remote-id vlan
Use this command to clear the DHCP Option-82 Remote ID for a VLAN and subscribed service
(based on subscription-name).
dhcp l2relay vlan
Use this command to enable the DHCP L2 Relay agent for a set of VLANs. All DHCP packets which
arrive on interfaces in the configured VLAN are subject to L2 Relay processing. vlan–list range is
1–4093. Separate non-consecutive IDs with a comma (,), and do not insert spaces or zeros
between the range. Use a dash (–) for the range.
Format dhcp l2relay circuit-id vlan <vlan-list>
Mode Global Config
Format no dhcp l2relay circuit-id vlan <vlan-list>
Mode Global Config
Format dhcp l2relay remote-id <remote-id-string> vlan <vlan-list>
Mode Global Config
Format no dhcp l2relay remote-id vlan <vlan-list>
Mode Global Config
Default disabled
Format dhcp l2relay vlan <vlan-list>
Mode Global Config