EasyManuals Logo

NETGEAR ProSAFE M7100-24X Reference Manual

NETGEAR ProSAFE M7100-24X
636 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #467 background imageLoading...
Page #467 background image
Utility Commands
467
ProSAFE M7100 Managed Switches
no debug vpc peer-link
This command disables debug traces for control messages or data messages that are exchanged
betw
een MLAG devices on the MLAG peer link.
debug vpc peer detection
This command enables debug traces for the dual control plane detection protocol (DCPDC).
Traces are detected when the DCPDP transmits and receives detection packets to and from the
MLAG peer switch.
no debug vpc peer detection
This command disables debug traces for the dual control plane detection protocol (DCPDC).
show debugging
This command displays the packet tracing configuration.
The following CLI output is an example of the command output.
(Netgear Switch) #show debugging
Arp packet tracing enabled.
Format no debug vpc peer-link {control-message | data-message}
Mode Privileged EXEC
Format debug vpc peer detection
Mode Privileged EXEC
Format no debug vpc peer detection
Mode Privileged EXEC
Format show debugging
Mode Privileged EXEC

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSAFE M7100-24X and is the answer not in the manual?

NETGEAR ProSAFE M7100-24X Specifications

General IconGeneral
BrandNETGEAR
ModelProSAFE M7100-24X
CategorySwitch
LanguageEnglish

Related product manuals