NETGEAR ProSAFE M7100-24X - Classofservice Trust; Cos-Queue Min-Bandwidth

Quality of Service (QoS) Commands
221
ProSAFE M7100 Managed Switches
no classofservice ip-dscp-mapping
This command maps each IP DSCP value to its default internal traffic class value.
classofservice trust
This command sets the Class of Service trust mode of an interface. You can set the mode to trust
one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also set the
interface mode to untrusted. If you configure an interface to use Dot1p, the mode does not
appear in the output of the show running config command because Dot1p is the default.
no classofservice trust
This command sets the interface mode to the default value.
cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface
queue. The total number of queues supported per interface is platform-specific. A value from
0–100 (percentage of link rate) must be specified for each supported queue, with 0 indicating
no guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
no cos-queue min-bandwidth
This command restores the default for each queue's minimum bandwidth value.
Format no classofservice ip-dscp-mapping
Modes Global Config
Default dot1p
Format classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted}
Modes • Global C
onfig
• Interface Config
F
ormat no classofservice trust
Modes • Global Config
• Interface Config
F
ormat cos-queue min-bandwidth <bw-0> <bw-1> ... <bw-n>
Modes • Global Config
• Interface Config
F
ormat no cos-queue min-bandwidth
Modes • Global Config
• Interface Config