NETGEAR ProSAFE M7100-24X - Sntp Server; Sntp Unicast Client Poll-Retry; Sntp Source-Interface

Utility Commands
416
ProSAFE M7100 Managed Switches
no sntp unicast client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default value.
sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
sntp server
This command configures an SNTP server (a maximum of three). The optional priority can be a
value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
no sntp server
This command deletes a server from the configured SNTP servers.
sntp source-interface
Use this command to specify the physical or logical interface that must be used as the source
interface (that is, source IP address) for the SNTP unicast server configuration. The address of
the source interface is used for all SNTP communications between the SNTP server and the SNTP
client. The IP address of the source interface is used in the IP header of management protocol
packets. Using the IP address in the IP header enables security devices such as firewalls to identify
Format no sntp unicast client poll-timeout
Mode Global Config
Default 1
Format sntp unicast client poll-retry <poll-retry>
Mode Global Config
Format no sntp unicast client poll-retry
Mode Global Config
Format sntp server {<ipaddr> | <ipv6addr> | <hostname>} [<priority>
[<version> [<portid>]]]
Mode Global Config
Format no sntp server {<ipaddr> | <ipv6addr> | <hostname>}
Mode Global Config