Security Commands
295
ProSAFE M7100 Managed Switches
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled, the
dot1x configuration is retained and can be changed, but is not activated.
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set.
Default disabled
Format dot1x re-authentication
Mode Interface Config
Format no dot1x re-authentication
Mode Interface Config
Default disabled
Format dot1x system-auth-control
Mode Global Config
Format no dot1x system-auth-control
Mode Global Config
To Next Page
Loading...
Need help?
General