Switching Commands
122
ProSAFE M7100 Managed Switches
set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that the
switch remains in Non-Querier mode once it has discovered that there is a Multicast Querier in
the network.
no set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period to its default value.
set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to send
periodically.
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process
when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the
Snooping Querier finds that the other Querier’s source address is better (less) than the Snooping
Querier’s address, it stops sending periodic queries. If the Snooping Querier wins the election,
then it will continue sending periodic queries.
Default 60 seconds
Format set igmp querier timer expiry <60-300>
Mode Global Config
Format no set igmp querier timer expiry
Mode Global Config
Default 1
Format set igmp querier version <1-2>
Mode Global Config
Format no set igmp querier version
Mode Global Config
Default disabled
Format set igmp querier election participate
Mode VLAN Config
To Next Page
Loading...
Need help?
General