NETGEAR ProSAFE M7100-24X Reference Manual

Management Commands
551
ProSAFE M7100 Managed Switches
show trapflags
Use this command to display trap conditions. The command’s display shows all the enabled
OSPFv2 and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or
disabling the trap condition. If a trap condition is enabled and the condition is detected, the SNMP
agent on the switch sends the trap to all enabled trap receivers. You do not have to reset the
switch to implement the changes. Cold and warm start traps are always generated and cannot be
disabled.
Format show trapflags
Mode Privileged EXEC
Term Definition
Authentication
Flag
C
an be enabled or disabled. The factory default is enabled. Indicates whether authentication
failure traps will be sent.
Link Up/Down
Flag
C
an be enabled or disabled. The factory default is enabled. Indicates whether link status traps
will be sent.
Multiple Users
Flag
C
an be enabled or disabled. The factory default is enabled. Indicates whether a trap will be
sent when the same user ID is logged into the switch more than once at the same time (either
through Telnet or the serial port).
Spanning Tree
F
lag
C
an be enabled or disabled. The factory default is enabled. Indicates whether spanning tree
traps are sent.
ACL Traps Might be enabled or disabled. The factory default is disabled. Indicates whether ACL traps
are sent
.
DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps
are sent
.
OSPFv2 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are
sent. If any of the OSPF tr
ap flags are not enabled, the command displays disabled.
Otherwise, the command shows all the enabled OSPF traps’ information.
OSPFv3 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are
sent
. If any of the OSPFv3 tr
ap flags are not enabled, the command displays disabled.
Otherwise, the command shows all the enabled OSPFv3 traps’ information.
PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are
sent
.

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English