Quality of Service (QoS) Commands
268
ProSAFE M7100 Managed Switches
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the int
erface(s) in a given
direction.
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6 ACL.
Use the <name> parameter to identify a specific IPv6 ACL to display.
Format ipv6 traffic-filter <name> {{control-plane | in | out} | vlan
<vlan-id> {in | out}} [sequence <1-4294967295>]
Modes • Global Config
• Interface Config
F
ormat no ipv6 traffic-filter <name> {{control-plane | in | out}| vlan
<vlan-id> {in | out}}
Modes • Global C
onfig
• Interface Config
Format show ipv6 access-lists [<name>]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the IPv6 ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are True or False.
Protocol The protocol to filter for this rule.
Source IP Address The source IP address for this rule.
Source L4 Port
K
e
yword
The source port for this rule.
Destination IP
Addres
s
The destination IP address for this rule.
Destination L4
Por
t Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.
Flow Label The value specified for IPv6 Flow Label.
Log Displays when you enable logging for the rule.
To Next Page
Loading...
Need help?
General