NETGEAR ProSAFE M7100-24X - Show Interfaces Status

Utility Commands
380
ProSAFE M7100 Managed Switches
show interfaces status
This command displays information about all interfaces or a specified interface. The output,
includes the interface description, port state, speed, and auto-negotiation capabilities. The
interfaces that are displayed in the output include physical interfaces, LAG interfaces, and VLAN
routing interfaces.
Although the output of the show interfaces status command is similar to the output of the show
port all c
ommand (see show port on page 26), it displays additional fields such as the interface
description and whether the port capability is Cisco-compliant.
The description of the interface is configurable through the description command (see
description on page 23). Although you can configure a description with a maximum length of 64
characters, the output of the show interfaces status command truncates the description to 28
char
ac
ters. You can display the long form of the description in the output of the show port
description command (see show port description on page 27).
Term Definition
Vendor Name The vendor name is a 16-character field that contains ASCII characters, is left-aligned, and is
padded on the right with ASCII spaces (20h). The v
endor name is the full name of the
corporation, a commonly accepted abbreviation of the name of the corporation, the SCSI
company code for the corporation, or the stock exchange code for the operation.
Length (50um,
O
M2)
This v
alue specifies the link length that is supported by the transceiver while operating in
compliance with applicable standards using 50 micron multimode OM2 [500MHz*km at
850nm] fiber. A value of zero means that the transceiver does not support 50 micron
multimode fiber or that the length information must be determined from the transceiver
technology.
Length (62.5um,
O
M1)
This v
alue specifies link length that is supported by the transceiver while operating in
compliance with applicable standards using 62.5 micron multimode OM1 [200 MHz*km at
850nm, 500 MHz*km at 1310nm] fiber. A value of zero means that the transceiver does
not support 62.5 micron multimode fiber or that the length information must be determined
from the transceiver technology
Vendor SN The vendor serial number is a 16-character field that contains ASCII characters, is
lef
t-aligned, and is padded on the right with ASCII spac
es (20h). This field defines the vendor
serial number for the transceiver. All zeros in the 16-byte field indicates that the vendor SN
is unspecified.
BR, nominal The nominal bit signaling rate is specified in units of 100 MBd, rounded off to the nearest
100 MBd. The bit r
at
e includes the bits that are necessary to encode and delimit the signal
and the bits that carry data information. A value of 0 indicates that the bit rate is not
specified and must be determined from the transceiver technology. The actual information
transfer rate depends on the encoding of the data, as defined by the encoding value.
Vendor Rev The vendor revision number contains ASCII characters, is left-aligned, and is padded on the
right with ASCII spac
es (20h). This field defines the v
endor product revision number. All
zeros in this field indicates that the vendor revision is unspecified.