NETGEAR ProSAFE M7100-24X - Hypertext Transfer Protocol (HTTP) Commands; Ip Http Server; Ip Http Secure-Server

Management Commands
510
ProSAFE M7100 Managed Switches
no crypto key generate dsa
Use this command to delete the DSA key files from the device.
Hypertext Transfer Protocol (HTTP) Commands
This section describes the commands you use to configure HTTP and secure HTTP access to the
switch. Access to the switch by using a Web browser is enabled by default. Everything you can
view and configure by using the CLI is also available by using the Web.
ip http server
Use this command to enable access to the switch through the Web interface. When access is
enabled, the user can log in to the switch from the web interface. When access is disabled, the
user cannot log in to the switch's web interface. Disabling the Web interface takes effect
immediately. All interfaces are affected.
no ip http server
Use this command to disable access to the switch through the Web interface. When access is
disabled, the user canno
t log in to the switch's web interface.
ip http secure-server
Use this command to enable the secure socket layer for secure HTTP.
Format no crypto key generate dsa
Mode Global Config
Default enabled
Format ip http server
Mode Privileged EXEC
Format no ip http server
Mode Privileged EXEC
Default disabled
Format ip http secure-server
Mode Privileged EXEC